****** Notice ****** |3 [5 j- q& A; L# J0 R
| Newtons method failed to converge in 100 iterations. This |$ _3 F9 \: m9 M$ W/ g- L; H1 P
| occurred while computing the following variable: |- M! T& _0 u. E+ ?* L5 g, ~! B! L
| |# P: o( F& D# T. w$ h u
| Variable Name : Temperature |! `2 j1 _9 t# {( L9 b- ?
| Location Name : FULID |6 S! W! z$ y4 B% f0 o. K
| Mesh location : VERTICES | 4 Q" g+ _( C8 \; q A7 R | Mesh entity : | # g# O' _/ ? a. {! r$ U! v | Last 3 Changes : 5.01272E-02 2.98919E-02 1.62209E-01 |8 Z. M8 Y2 J$ _% ?. C3 t
| Tolerance : 1.0000E-02 |* {6 ^ u4 y* S1 ?8 X+ D
| | * |3 ~' O7 A' w+ K1 {: c( H | The Newton iteration was diverging. The solver will continue | " y" F! T6 ~. y* H& g+ | | with the variable field as it was on the final iteration. If |$ t5 }+ |4 P: N
| this situation continues you might try decreasing the Newton | - y+ X0 k/ Z5 p% S1 ~ | iteration under relaxation factor. This can be changed by |- Y0 [* i0 `( k o% V( T* E
| setting one of the following parameters: |; ]3 J4 e# G" {% r! V' g
| |. E Q8 \3 g- {# ^0 Z/ |) [
| Temperature : "Constitutive Relation Under Relaxation" |7 ?* n8 F/ ^" K
| Pressure : "Newton Pressure Under Relaxation" |& D* g% @; O: w, L7 X& ~
| | * n4 T7 `5 t; w7 X | for your mixture using the definition file editor. , C# S( S0 ^1 y3 |# T9 ~
算到104步左右就不算了，或者出错显示，the ansys cfx solver exited with return code1. no result file has been created. 每次都是在80步，或104步左右出错或停止运算。这是什么原因啊，重画网格还是一样，出错好几十次了。我修改残差或者减小时间步还是出错。请教各位高手，是我网格有问题还是 cfx设置有错？跪求啊，，
/1 
IP卡
狗仔卡
发表于 2013-10-23 14:33
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡